Author Topic: Help repairing Bride Brix recliners.  (Read 335 times)

Offline Skifledanabit

  • Major Contributor
  • ***
  • Posts: 1,247
  • Karma: +10/-0
    • View Profile
Help repairing Bride Brix recliners.
« on: June 22, 2015, 05:34:41 PM »
Hi all. Typical issue with seats, I've got a bride Brix 1 and 2, both are looking worse for wear on the bolsters, the 1 in particular. Is there any way I can replace the foam and fabric? It's so bad that the metal support is showing.

Any ideas?
1989 Gen 2 EGi http://www.missbanzai.net
[SIGPIC][/SIGPIC]

Offline rote8

  • MRC Full Club Member
  • Contributor
  • *****
  • Posts: 306
  • Karma: +10/-0
    • View Profile
Re: Help repairing Bride Brix recliners.
« Reply #1 on: June 22, 2015, 06:25:36 PM »
I would respectfully suggest that this is probably not a DIY project to make it look the part. Professional re-trimming should not be too expenses.
Finance dictated it had to go 13 months ago,  after 14 years in an RX8 regretted ever since.

Offline Skifledanabit

  • Major Contributor
  • ***
  • Posts: 1,247
  • Karma: +10/-0
    • View Profile
Re: Help repairing Bride Brix recliners.
« Reply #2 on: June 22, 2015, 11:46:15 PM »
I wasn't even going to attempt to DIY it. Although, I did notice replacement foam for the Brix II, however that isn't my main concern. I've had a bad experience with a re-trim outfit around my way so I could do with a good pointer.
1989 Gen 2 EGi http://www.missbanzai.net
[SIGPIC][/SIGPIC]