Next MOD .........
Hi back with another Mod build I needed to do this as the ATH hinsburger Front end although its good I needed to have some form of protection and make the front bumper more ridged...... I did not like the look of the splitter type ones you can buy and I need to make mine a three piece project .................
So take some 3.0 mm aluminium plate cut two pieces 120 cm x 25 cm
This allows you to make a curve once cut place the ally on the underside of the front bumper to mark out your mounting holes and make a general shape then its back to the bench for moulding out with a hammer and files ...
once you got a rough shape the keep offering it up to the front bumper to make sure that you got the look you want I added a few bits of my own see pics for some shaping I used chemical metal bond
After your happy with your end result then bolt it up on the bumper to make sure you to canards/splitters look and have the same pitch then it was on to make the centre part this is made from a Ford focus front grill just cut it down and shaped it
Once I had done this I sent all the parts to Wicked Coatings Poole to Cover the parts in Carbon fibre effect hydro Dip
Back from hydro dipping then i added some Edging of split Rubber and some Mesh wire grill
Then just fitted the 3 pice kit to the car I also made some strakes out of aluminium 7 mm X 15 mm shaped and drilled two threaded rear mounting holes these have been placed just above the canard see photo,s
The finish touch was to use a thick layer of tiger seal the reason for this if you shape the seal and make it flush it will then stop any grit leafs general road shit getting it and make it easier to clean
Ally cost £55.40
ford focus grill £4.50
tiger seal £ 5.60
Split Rubber seal £ 1.75
Mesh Grill £2.20
Tools and time around 3 hours .......
Gas heat torch
8mm Drill bit
Very happy this end product is the second set I have made :lol:
Thank You for Taking The Time To Look