After falling out with my FD back in the summer (after it sh@t itself hours before TOTB) I finally put some TLC in and then drove down to Reworx Chrismas eve to finally get a power figure from it. For those of you that don\'t know the car, I built a dual turbo setup, constructing my own bespoke manifold and downpipe. I used two hybrid turbo\'s, that I made up from turbo II compressors and 12a turbo exhaust housings (AR 0.55) I ported the engine (developing my own port design) the intercooler is also a bespoke unit which I was developing for my old company (sensetuning) before my full time job took over all my spare time.
Anyway the rest of the engine setup is:
Power FC
Greddy profec B boost controller
Sensetuning sandwich plate injector assembly (4 x 550cc additional)
Sensetuning front mount intercooler
Apexi GT spec exhaust
Apexi twin chamber BOV
Bosch 044 fuel pump
Sensetuning swirl pot
HKS 11.5 plugs
The fuel system had been replaced sinse TOTB due to fuel pressure issues with the previous dual pump setup. We spent a few hours tuning and grinning more and more as the HP figures steadily climbed, for those of you that have tuned on the dyno, it is fairly addictive to keep increasing boost which I did, peak RWHP was 405 at 1.1Bar boost 310 FtLb torque, when I opted to turn up the boost controller to max and go for glory at which point she decided that that was enough at peak torque and 1.3 Bar boost she spat a tip or two out of the rear rotor, So after rebuilding it and increasing the exhaust ports slightly she is now running at a Bar and around 375 RWHP which is fairly lively in these conditions.
How do I get this figure installed into the database?
Engine built by Sensetuning
Tuned by RE Worx
