Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bin liner

Pages: 1 ... 20 [21]
301
3rd generation RX-7's / is this an unidentified RZ?
« on: July 19, 2004, 09:52:57 PM »
There were 300 built in the first production run, late \'92. Another 150 built in \'95 with slight revisions.Then another 175 built in the last production run, the mica pearl white models with the red recaros.

302
Anything Engine/Performance/Tuning related / Pulley Kit
« on: July 11, 2004, 11:31:39 PM »
Quote
Originally posted by iiyama
You can remove the air pump with Unorthodox pulley\'s as they make a kit to do exactly this.

http://unorthodoxracing.com/cgi-bin/merchant2/merchant.mv?Screen=PROD&Store_Code=URI&Product_Code=010870802

Ian
I\'ll rephrase, the UR full pulley kit by itself does not eliminate the air pump. As stated it can be done though. The air pump elimination kit can be used for this or with the standard pulleys to do this.

303
Anything Engine/Performance/Tuning related / Pulley Kit
« on: July 11, 2004, 09:44:55 AM »
The Unothodx racing full pulley kit does not eliminate the air pump.It underdrives the alternator power steering and waterpump by using a smaller main pulley.
The rest of the pulleys are the same size as standard, although you can remove the airpump with this kit or even with your standard set-up but the easiest way is to use the GReddy pulleys.Personally i don\'t like it as it leaves very little contact patch between belt and waterpump pulley.

Unorthodox full pulley kit-£300.00

304
3rd generation RX-7's / Block rebuild Pics
« on: June 11, 2004, 05:44:55 PM »
Quote
Originally posted by Adam
Sorry missed a pic off :)
Nice clean work, watch it don\'t slide off that bench!:D
What spec are you taking it to?

305
Anything Engine/Performance/Tuning related / Turbo leaking oil
« on: June 10, 2004, 10:29:55 PM »
Nice to see you on board IGY:)

306
Anything Engine/Performance/Tuning related / Turbo leaking oil
« on: June 10, 2004, 12:11:10 AM »
Your oil feed line is three times the size it should be.You need a -3AN feed. You also need to make your drain a -10 or -12, bigger is better here.

307
If your inlet gasket was going then it is probably that otherwise i would first check the vacuum lines.

308
Anything Engine/Performance/Tuning related / tuning
« on: November 03, 2003, 10:08:27 PM »
Thor are in need of the work.They\'re not going to turn you away but as for whether they can pull out the goods then that is another story.

Pages: 1 ... 20 [21]