Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Clarky

Pages: 1 ... 6 [7] 8
91
Rotary and General Chit-Chat / Membership card
« on: February 08, 2006, 08:38:05 AM »
Got my new membership card today very nice card & design

92
General Technical / Speedo Sensor cant find it?
« on: January 11, 2006, 03:22:28 PM »
Jacked up my fd nice and high, with my new (800mm lift high trolley jack), to change the speedo sensor i have the diagram of where it is on the tranmission, but!!  i cant find it, can anyone give me idoits directions where it is, even a photograph.
thanks

93
Anything Engine/Performance/Tuning related / Engine Performane Upgrade
« on: December 06, 2005, 12:58:37 PM »
Im planning a engine rebuild and performance upgrade in january, but i need help in deciding what to do from the more knowledgable people or vendors on here, likely cost would be good.
The only mods i have at the moment is apexi fc, larger catback make unknown, twin apexi filters.
Dont want to go too mad as it will mostly be for road use, and maybe the odd strip run just for fun, want it to be driveable.
Budget up to £4500.ish

94
Rotary and General Chit-Chat / Price Falling
« on: November 25, 2005, 02:03:28 PM »
Just wondered why there has been a contstant price fall of FDs, is there too many now being imported, people just dont want them, or the cost of repair, or insurance, or just a blip in the market.
Does this mean there might be a reduction of the cost of rebuilds, and parts, or am i wishful thinking.....

95
Rotary and General Chit-Chat / Sussex Performance Centre
« on: November 24, 2005, 10:08:26 PM »
Just found out about Sussex Performance Centre, has anyone had any work done by this company, as they supply and fit tuning goodies for thr FD
 
 
http://www.sussexperformancecentre.com/

96
I. C. E. & Electrical / Speedo sensor
« on: November 17, 2005, 09:26:22 AM »
I have installed the kph to mph conversion, but speedo does not work, have checked all wiring is correct, so replaced dial still not working, fitted apexi fc commander thought i could use that for speedo readings, thats does not read either, the only conclusion is that it is the speedo sensor has a fault, anyone else had this problem.

97
Rotary and General Chit-Chat / Washer
« on: November 13, 2005, 01:58:59 PM »
Trying to fill the dishwasher, with a pup this size aint easy i have forgot what hard work puppies are, ive not been so knacked for years, cant believe how much engery he has compared to our older dog, but i would not be without him now he is for life!!

98
General Technical / Apexi Filters/Standard Box
« on: November 08, 2005, 12:45:09 PM »
I fitted Twin Apexi Filters, put in some heat shielding and extra ducting, air temperature was at highest 58 degrees, too high i think so put back standard air filter box to see what the difference in temps would be. ( have power fc but did not check on standard box before i fitted apexi\'s) air temp with standard box 50 degrees still to hot, apexi fc not mapped yet,, so im not sure what conclusions i have come to, any suggestions please.

99
General Technical / Apexi Filters/Standard Box
« on: November 08, 2005, 12:44:33 PM »
I fitted Twin Apexi Filters, put in some heat shielding and extra ducting, air temperature was at highest 58 degrees, too high i think so put back standard air filter box to see what the difference in temps would. ( have power fc but did not check on standard box before i fitted apexi\'s) air temp with standard box 50 degrees still to hot, apexi not mapped yet,, so im not sure what conclusions i have come to, any suggestions please.

100
General Technical / Speedo Sensor
« on: September 29, 2005, 11:47:54 AM »
Can anyone tell me where the speedo sensor is, and can it be checked.

101
General Technical / mapping
« on: September 28, 2005, 10:14:46 AM »
Ive fitted my new apexi fc commander ready for future mods, run idle setup all ok, i have an aftermarket exhaust and backbox, still have cat fitted,
Is there a definitive answer to, do i need to get it mapped? before i redline it again.

102
Rotary and General Chit-Chat / What are you doing?
« on: September 20, 2005, 05:15:32 PM »
What are you doing with your Rex during the Winter months?

103
I. C. E. & Electrical / kph to mph
« on: August 06, 2005, 09:27:18 PM »
I have a protech kph to mph converter on my fd, my speedo is not working, i have a black wire that has come off, anyone know where this goes on the speedo, or is it a negative feed.
john

104
General Technical / Over Rev Buzzer
« on: June 28, 2005, 08:48:53 PM »
Just wondered what sought of speed other fds (mine is standard) are obtaining in second gear when the over rev buzzer shouts out! mine comes on at about 80mph is this average.
John

105
Wheels & Tyres, Suspension & Brakes / Bump Steering
« on: June 25, 2005, 03:44:17 PM »
My FD seems to suffer from bump steering, and makes the car feel twitchy and unstable, and does not give me confidence in the handling, standard setup as far as i know, on a nice new laid road its really smooth.
I know the Rex has hard suspension, but is this normal, a fault, or is it the state of our roads.
Any help please.
John

Pages: 1 ... 6 [7] 8