Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - SW7

Pages: [1] 2 ... 4
General Technical / Combined Front Strut Brace & Engine Damper
« on: December 13, 2018, 11:05:15 AM »
Does anyone have any experience of using a Combined Front Strut Brace & Engine Damper, if so what do you think and which brand/make do you recommend?
Cheers :)

Events Calendar / Re: Huge Thanks to all who made 7/7 Very special
« on: July 16, 2018, 08:16:43 PM »
Hi Clive,
Was a great day, well worth the trip, thanks very much indeed.

Chatting to Clive now, should have just called first instead of posting  :13:

Hi all,
Does anyone know where you can buy replacement camber bolts for the lower front and rear control arms for a 1993 FD?

Received my email and replied  :13:

Hi, just wondering if anyone has heard from Mazda about the 7th?

I also want any replacement front bumper to work with the stock wings as some of them look like they need wider wings.

Has anyone bought and fitted one if the lips in the link below, looks like a good option but you never know the fit till you've tried it.

Hi Clive,
I hope you are well, it's been a while.
I'm looking to go for a different look but with all the different people selling aftermarket bumpers I'm not sure who is good and who isn't as the pictures and sales adverts never give you the full story plus don't cover what other parts you might need to go with a new bumper, of course there is the 99 spec option it's just likely to be an expensive option.
Any info or advice would be very welcome.
Many thanks.

3rd generation RX-7's / 93 Spec Car Front Bumper Upgrade Question
« on: May 18, 2018, 07:12:15 AM »
Hi All
Just looking for advice on which vendors to look at for good quality front bumper that will fit a 93, I don't want to buy something only to find it's poor quality or a poor fit and don't know any of the body part suppliers as have a stock body to date.

Events Calendar / Re: Frey’s Mazda Classic Car Museum - Road trip
« on: May 10, 2018, 07:50:05 PM »

Clive & Lisa
Steve (SW7)

Have been a bit under the weather today and it's pouring down so postponed investigation session until tomorrow

It was attached, my wonder is whether the fact it comes up through my heat shield has cooked the wire inside the heat shield next to the turbo

Thanks for the tip, looked up how to check on the power fc and just tried it and 02 stuck on 0.1v so looks like it's gone kaput.

Pages: [1] 2 ... 4