Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - SW7

Pages: [1]
1
General Technical / Combined Front Strut Brace & Engine Damper
« on: December 13, 2018, 11:05:15 AM »
Hi,
Does anyone have any experience of using a Combined Front Strut Brace & Engine Damper, if so what do you think and which brand/make do you recommend?
Cheers :)
Steve

2
Hi all,
Does anyone know where you can buy replacement camber bolts for the lower front and rear control arms for a 1993 FD?

3
Hi,
Has anyone bought and fitted one if the lips in the link below, looks like a good option but you never know the fit till you've tried it.
https://www.ebay.co.uk/itm/Mazda-RX-7-FD3-93-97-Front-OEM-R-PACKAGE-Lip-Splitter-PU-Polyurethane-Black-/142710437615

4
3rd generation RX-7's / 93 Spec Car Front Bumper Upgrade Question
« on: May 18, 2018, 07:12:15 AM »
Hi All
Just looking for advice on which vendors to look at for good quality front bumper that will fit a 93, I don't want to buy something only to find it's poor quality or a poor fit and don't know any of the body part suppliers as have a stock body to date.
Thanks
Steve

5
Hi All,

Just wondering if there are any rotary experienced guys out there in the bristol area, my rx was fine for 20 minute gentle run in after a service midweek then developed A very bad turn and struggles to turn over.

Am going to start investigating tomorrow before booking the trailer to ship her to wgt in cheshire plus Pip is away for two weeks, wondered if anyone was local who might lend a hand.

6
General Technical / Accusump in RX7 Gen 3
« on: June 08, 2016, 06:45:24 PM »
HI All,

Has anyone installed / used an Accusump in the RX7?

All comments / thoughts welcome especially if youv'e used one.

Cheers

7
Wanted Items / Wanted - stock oil filler neck
« on: June 08, 2016, 03:33:12 PM »
Wanted a stock oil filler neck.

Am going to design and fabricate a new filler neck with built in catch can and vent so need a standard neck for a template.

Thanks

8
Wanted Items / Rear Diffuser Rear Wing Mounts
« on: May 27, 2016, 10:29:11 AM »
I have just received my diffuser but it doesnt come with the curved rear side mount the mount to the bottom of the rear wings.

If anyone has or know where I can purchase these please let me know.

9
General Technical / Turbo jacket, Yes or No?
« on: May 25, 2016, 06:57:03 PM »
Now I have gone single my GT35/40 is putting out a massive amount of heat and I'm concerned about my new Concept 7 fish gill hood and the heat as its fibreglass.

My turbo and downpipe currently have no heat shield or turbo blanket and am wondering if a turbo blanket is a good idea of it it would mean to much heat being retained around the turbo itself and possibly damaging it.

Any feedback welcome.

10
General Technical / Tegiwa Brake Stopper Installation Question
« on: May 25, 2016, 02:50:32 PM »
Hi,

Does anyone have any instructions for the Tegiwa Brake Stopper?

One piece is obvious the second is not.

Cheers

11
Has anyone got a set of or know who might sell brake disc shields with built in ducts for the connection of hoses?

Have searched online but nothing for sale comes up.

Example in the link below

http://www.rx7club.com/race-car-tech-103/brake-setup-my-race-car-723283

12
Wanted Items / Who Stocks K-Sport 330 Brake Kits
« on: May 20, 2016, 04:08:54 PM »
HI All,

From my calls to date most places appear to have to order in the K-Sport 330mm kits for the RX7 which can take from 4 weeks to 12 weeks.

Does anyone know of anyone who does carry them in stock??

Cheers
Steve 

Pages: [1]