Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - steve garbutt

Pages: [1] 2 ... 58
Booked room and payment sent for Michelle and myself :)

Hi Lisa

Could you put Michelle and myself down :)

Old school Mazda's / Re: My new RX3 and restoration
« on: September 03, 2015, 05:06:43 PM »
cheers Guys :)
yep The September edition on Retro Cars :)
Was a fantastic day and there has been some interest in getting it in other magazines as well :)
Well chuffed with the outcome :) i just need another project now haha :)

:D ;D wondered when you'd wake up. Looking forward to catching up with you.  :)

Just about out of my winter slumber :)
Yep gonna be good to catch up with you, Tina and everyone else :)

Payment sent add me to the list please

Steve & Michelle Garbutt - Mazda RX3

Is it too late to add names to the list ?

General Technical / Rotary Engine With One Moving Part
« on: September 15, 2014, 10:24:19 AM »
Sore this back in 2012 and if i remembered correctly they made a working version but the energy produce wasnt much more than the energy required to move the parts in the first place, so the output was very weak.

Old school Mazda's / Importing old RX from Usa?
« on: August 20, 2014, 09:51:41 AM »
the only thing that i can thing would make it worth less money here, is that it would be left hand drive coming from the US.

Events Calendar / Rotoarystock 2015 - Holland
« on: August 10, 2014, 04:02:59 PM »
Im interested in this, not 100% sure yet but deffo interested :)

Old school Mazda's / My new RX3 and restoration
« on: August 06, 2014, 11:53:57 AM »
Thank you Jarno :D
Ill update this thread in a few days :)

not 100% accurate but a good indecation as to how many are actually left on the road

Well iv made every Rotorstock since Rotorstock 3 and iv enjoyed everyone of them :)
The 250 mile round trip in the RX3 and rain was exciting to say the least but always well worth the journey.
Ill be sorry to see Rotorstock fade away, as me and Michelle have enjoyed everyone we have attended.
Thank you Clive and Lisa for all the effort you have put in over the years.

first thing to try is plug your old ecu back in and take it for a drive.

Events Calendar / Rotorstock day & w/end tks now available to buy!
« on: June 29, 2014, 11:23:00 PM »
Purchased 2 tickets :)

General Technical / Importance of Rear Wing Support
« on: June 23, 2014, 05:21:46 PM »
If carbon is layered in different directions as it should be in a quality product that is manufactured for strength not weight, then it wont completely snap, it will bend, as some of the fibers will remain connected.
Single layer carbon will just snap but thats usually reserved for either cheap products or very light products.

Pages: [1] 2 ... 58